Axle brackets

I used a reducer bushing instead of a plug on the axle brackets. No hole drilling. A washer on the end allows the nut to tighten down. Since there is a steel fence railing in the pipe the inner bracket attaches to, I used a zip tie to clamp the end onto the frame. It won't rust! I hope it has enought tensile strength for any pressure it must withstand.

steering - axle cap2

Got the 1" cap, bought a 1" washer, and bought a drill bit for a 7/8" hole in the cap. Photo 2: I had to use the shop's drill because holding the cap and drilling it with a hand drill was an exercise in futility.

Photo 3: bolt, washer, nut. Photo 4: Installed on axle Photo 5: Pipe showing the steering column in place. Cap spins freely because nut not tightened down.