Got the 1" cap, bought a 1" washer, and bought a drill bit for a 7/8" hole in the cap. Photo 2: I had to use the shop's drill because holding the cap and drilling it with a hand drill was an exercise in futility.
Photo 3: bolt, washer, nut. Photo 4: Installed on axle Photo 5: Pipe showing the steering column in place. Cap spins freely because nut not tightened down.
.JPG)
.JPG)
Got the 1" cap, bought a 1" washer, and bought a drill bit for a 7/8" hole in the cap. Photo 2: I had to use the shop's drill because holding the cap and drilling it with a hand drill was an exercise in futility..JPG)
.JPG)
.JPG)
.JPG){kind=link}
.JPG){kind=link}
No comments:
Post a Comment